Most of the compressor pipes enter from the auxiliary shaft or the mixing shaft to facilitate the acquisition and maintenance. The compressor pipes in the shaft are usually fixed with guide clamps to prevent the pipes from being bent and displaced laterally. The longitudinal weight of the pipeline is supported by the support pipe seat, which is installed on the special steel beam in the shaft. The compressor pipe in the inclined shaft can be laid with pipe pier, while the compressor pipe in the drift is mostly supported by the cantilever beam on the sidewalk side. The span of the support beam and pipe pier of the second pipe is determined based on the strength and rigidity of the supported pipe. In addition to the pipe itself and its auxiliary devices, the load of the pipe should also consider the weight of the water filled in the pipe and the possible coating on the pipe. When the piping and installation of compressed air pipeline equipment are carried out, the prefabrication function of the pipeline cannot be really played.

Therefore, in the actual construction, we must envisage the construction process in advance, and install the corresponding prefabricated shell at the installation position of mercury and heat exchanger if relevant conditions permit. In the simulated on-site pre assembled pipe, after the on-site assembly is completed, the welded junction of the simulated on-site assembly is pulled back to the corresponding prefabrication plant, and the automatic equipment is directly used for welding, and the corresponding flange is connected with bolts. Air compression and cooling, dust removal, water and oil removal of compressed air moisture in compressed air comes from the atmosphere.

The application range of compressed air pipeline is wide, and correct installation is an important key. Paying attention to the basic installation principles common to any application type will ensure that the air compressor can exert high efficiency and performance. The air compressor constitutes a complete system through pipelines, valves and other equipment. Improper design, calculation and installation of compressed air pipeline will affect the economy and reliability of the whole system, and even bring serious destructive accidents. When necessary, the compressed air pipeline can be equipped with an air tank in the middle of the pipeline. The ring pipe is equivalent to a pressure vessel, which can ensure that the pressure is the same everywhere in the air compressor pipeline.