Under the increasingly strict control of the pressure vessels and pressure pipelines of special equipment, a new type of compressed air pipeline system was born, that is, aluminum alloy quick installation pipeline system. This full performance compressed air pipeline system is specially designed and produced for the air compression station system equipment. Compared with the original galvanized pipe and seamless steel pipe, the installation is simpler and more convenient. There is no need to twist the thread, no need to weld, and it can be disassembled for secondary use without any loss.

When the piping and installation of compressed air pipeline equipment are carried out, the prefabrication function of the pipeline cannot be really played. Therefore, in the actual construction, we must envisage the construction process in advance, and install the corresponding prefabricated shell at the installation position of mercury and heat exchanger if relevant conditions permit. In the simulated on-site pre assembled pipe, after the on-site assembly is completed, the welded junction of the simulated on-site assembly is pulled back to the corresponding prefabrication plant, and the automatic equipment is directly used for welding, and the corresponding flange is connected with bolts. Air compression and cooling, dust removal, water and oil removal of compressed air moisture in compressed air comes from the atmosphere.

The compressed air pipeline atmosphere generally contains a certain amount of moisture in vapor state. When the water vapor in the air is too much and exceeds its saturation (that is, when the relative humidity is greater than 10 0%, or when the air is cooled to below the dew point temperature, the water vapor in the air will condense into water droplets and precipitate). Generally, the compressed air pipeline needs to be equipped with one or more condensers to cool the compressed air. For example, connected to the air-cooled cooler at the rear of the air compressor, it can reduce the temperature of the high-temperature compressed air containing a large amount of water vapor in advance, and condense most of the water vapor into liquid water and discharge it out of the machine, so as to meet the requirements of the downstream purification equipment filters and dryers for the inlet air temperature.